Not fitted TRC One but from the other makes that we have seen fitted.
1/ Get somebody to help you hold it up in place and double check stuff before you drill.
2/ Much easier to fit if you can raise the front of the car
When I did mine I ran a thin strip of double sided tape around the splitter, measured out the center point of the bumper and splitter, then me and a friend positioned it in place! Tape holds it in place nicely to allow time for screws etc!
This! It's dead easy to remove the bumper, then gives you full access to bolt on properly.Take the bumper off and fit it will make it a lot easier for you
This! It's dead easy to remove the bumper, then gives you full access to bolt on properly.
Just make sure it's aligned properly, easiest way is to align the 'fins' that stick out a bit so they follow the same line as the lower grille opening.
Bumper off isn’t the easiest of jobs to be honest and the bumper is so flimsy when off it would be a PITA.Take the bumper off and fit it will make it a lot easier for you
Looks great!
I did mine over the weekend as well and used self tapping screws in the end. Seemed to hold strong and was alot easier and quicker. Anyone else used these and held well?