I cut and measured everything but as I only have access to metal welding I got someone to weld the pipes together. I'm a reasonable welder when it come to metal, and am sure I could weld aluminum as well, but no equipment means no practice.

But indeed, the welds are nice. I'm very pleased with the result and imo was well worth the time I put into it

except that damn SPlit R which I now have to reajust again lol!
 
here u go chrissy

2009-05-17_134902.jpg

2009-05-09_192218.jpg
 
Cheers ryan can't upload pics at the mo so a big thanks to you!
I have finally done all my pipework and a big thanks to reuvers, I went straight down with the charge pipe though not down by the horn, fits fine with the light on too. Hope you guys like it!
 
Cheers ryan can't upload pics at the mo so a big thanks to you!
I have finally done all my pipework and a big thanks to reuvers, I went straight down with the charge pipe though not down by the horn, fits fine with the light on too. Hope you guys like it!
 
good get it going mate! i will put up all the bits that i used when i can remember!
 
map sensor

Hi,

How can you mount the mapsensor in the custom piping?

Thanks
 
hi, just read this thread as iv split my hose on the intercooler on the universal setup from ebay on the join under the engine again! Would the 60 or 63mm make any difference? And which would best suit a k03 stage 2?
 
Last edited: