Took the window switches apart cleaned them! Also looked at what was under the guage pod on dashboard! Found a hole not a round one some people shouldn't use power tools ha

Sent from my GT-I9300
 
avadehep.jpg

Fitted this little bad boy
 
Changed my tweeter, window switch and cup holder :)

Then changed a couple pipes in the bay, Turbo outlet to DV, Rocker breather and the Intercooler to Inlet pipe... Was a PITA as the jubilee clip slides down the pipe and pops off when I try to tighten it so going to have a good look tomorrow!
 
Pretty sad state the country is in when guff like that has so much of a pull on the public....

totally agree there mate spot on.And then in the new yr there is dancing on shite...wtf is going on.and shr says to me some time on why do i watch wheeler dearlers so much or the like.
im not that into engine detailing that much but id rather do that than the shite factor...sit back simon while some 'no markes' get you aload of money.
remember there is always you tube ........;)

http://www.youtube.com/watch?v=PHXzrNyMc6I
http://www.youtube.com/watch?v=VF3yEFbGpcs if you like the older stuff:)
 
Ordered replacement wipers of ebay as the spring in my golf aeros as gone weak (drivers side).
A new one from vw/ecp was £40 ish....ouch!!!!!!
 
Took it for a drive to the father in laws gave it a bit of a polish then the guy who was fitting the in laws floor said "you can clean mine if you want it hasn't been cleaned for three years" we'll that's your own fing fault plus it's a rusty old tranny van do you think I'm going to waste my cleaning products on that shitty thing no so do one knob head
 
Just been and picked up a front splitter . A front strut brace. Cone filter with maf and heat shield. Re circ valve battery box and a few other bits and pieces. Plus got the coilovers to fit this weekend and oil & filter & spark plug change.