what have you done to your car today ?

[LCsTed]

Got put on notice that I am no longer required at my work...so planning how to spend my payout in Sep

Sent from my GT-I9300 using Tapatalk

 

[markpile]

That's ok lol gives me an excuse to play with me car lol

Sent from my C6603 using Tapatalk

 

[joshy514]

Fitted the wellycooler pics in my RR

 

[leonsussex96]

had it stopped and searched after being pulled over. swear the police have it in for younger drivers!

 

[D1andonlyantman]

had it stopped and searched after being pulled over. swear the police have it in for younger drivers!

That's coz you all be puffin on de ganja

 

[chads77]

Bought oil amd filter to do a service

 

[Ronin225]

Just done my 4th wheel bearing in 18 months

 

[ozaudio]

Just done my 4th wheel bearing in 18 months

buy better bearings or press them in correctly lol

 

[Ronin225]

Being an engineer by trade I don't use crap bearings, fitted too many to machines for them to fail in no time, SKF everytime

 

[stupot_1982]

Replaced N/S Outer CV boot. Sceptical about balancing of replacement drive shafts or I would have done that. Esp if I knew how much of a trivia it was lol

 

[Roohul]

Fitted new coolant temperature sensor and engine washer kit


Red Engine Bay Washer Kit by Roohul Islam, on Flickr


Left by Roohul Islam, on Flickr


Right by Roohul Islam, on Flickr

 

[T108]

Fitted cheap Unibrace copy, across behind the rear seats, impressed with how much its increased rear body stiffness

 

[turboboy111]

@roohul where did you get the washer kit from?

and @ t108 what is the brand of the brace and where did you get it from?



Thanks Jason

 

[T108]

Got the brace trom ebay, its a raceland item, comes in a horible silver colour so i sprayed it anthacite.

best mod for rear end handling since Rear ARB

 

[T108]

http://www.ebay.co.uk/itm/350628542081?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1439.l2649

 

[turboboy111]

Thanks bud been looking for one for a while do all golf mk4 rear strut braces fit? As their are a few I like but don't know weather to bite the bullet incase it didn't fit, I know we share same floor plan but wasn't sure on items like this

 

[T108]

well that one fits, most others should also, but this style plate attached at 4 locations will add much more stiffness than a bar typre rear brace

 

[nathan_20vt]

Replaced clutch master cylinder this morning. Back on the road again!

 

[Bouncerbeater]

Well, I actually drove mine today for about 12 miles. Joys of always being at work

 

[SLeon]

Washed it then done a little bit of engine bay colour coding