Logs off p-torque map

[Damoegan]

I've got a stage 1 p-torqu map on my mk4 IC and me & DPJ have done some loge early on today.

I'd just like some comments on them from people please, just to check everything is running ok

MAF

Boost

Intake temp

Thanks
Damien

 

[DPJ]

Sorry no one's responded, Damien.

As I said yesterday, they look fine to me - as P-Torque intended, I would think.

 

[__B3NNY__]

Looks like shes running well.

I thought the airflow figures should of been abit higher though?

 

[P-torque.co.uk]

As Dave said no problems there for the stage 1 software, very little timing pull.

The MAF hits 158g/s, this is usually a little higher at around 170g/s, but nothing to worry about

 

[DPJ]

Did you say that was a new Maf, Damien?

 

[Damoegan]

Yea Dave, got it a few days after my poor RR day results as I thought it was goosed. But now I'm puting it down to the good old dyno lottery

 

[DPJ]

Yea Dave, got it a few days after my poor RR day results as I thought it was goosed. But now I'm puting it down to the good old dyno lottery

Where did you get it from?

 

[Damoegan]

The gf brother inlaw works in a garage and I get my parts off his at cost price, he just gives me the invoice to pay. I think it is from VW.

 

[wild willy]

Duty cycle looks like the turbo has a little more left in it. I think your intake could be changed for a nice Jetex open cone filter which should put an extra 10g/sec on your maff reading.
Stage 2 calling.

 

[Damoegan]

Willy - I've got a green panel filter at the mo and I'm gona smooth the air box after my hols so that might help a little. I'm also gona get a forge TIP when I get back from hols which should defo help

 

[wild willy]

Willy - I've got a green panel filter at the mo and I'm gona smooth the air box after my hols so that might help a little. I'm also gona get a forge TIP when I get back from hols which should defo help

A smoothed airbox will help but a large open Jetex cone for about £50 will help alot more.

 

[Damoegan]

Now have a Forge TIP and smoothed airbox fitted and done some more logs today. Only improvment looks like it has smoothed out the MAF readings.

Might have to try a large open cone filter now.

 

[DPJ]

Know anyone that would lend you a MAF?

 

[Damoegan]

Not that I can think of mate. Do you think its not reading very well?

 

[DPJ]

I'd say your MAF is under-reading by 10%. I think its fueling slight leaner than it's being asked to (which would tie in). Everything else is fine - and it's a mild map. I'd like to bet it would go a bot better with a good MAF....

 

[Damoegan]

Think I need to try someone els' MAF and do a log to compare.

 

[kriso]

How did you do those logs? Just accelerating up through a gear for a few seconds? I need to log mine soon as I haven't done it with this car..

 

[m0rk]

flat piece of road*, 4th gear from low rpm to peak rpm - WOT, no lifting

*I always use my driveway

 

[kriso]

Ok cheers m0rk, I'll have a go on the driveway tomorrow.

 

[Damoegan]

I actualy done them in 3rd mate as 4th in a 5 speed car will leave you at silly speeds. £rd gear at red line is circa 90 mph so 4th will be 100+. Dave (DPJ) actualy done mine for me.