Just picked up an aftermarket one from eBay. Didn't work! Sending it back and getting a proper Bosch one.
Discovered that my current MAF has no wires inside of it. At all. Just an empty clip. That's just not right...
Ive been looking around and think im just going to buy one from GSF today. i also occasionally get a misfire for about 30 seconds then it goes away again. light flashes and its misfiring then stops and EML just stuck on. you think this could also be the reason why it keeps dropping into limp mode and having boost issues? think its a good idea to get new coil packs too?
MAF installed and general acceleration and performance is better but still get EML and limp mode
Have noticed air bubbles in the fuel line after going for a run so maybe a seal has gone funny on pipes near fuel filter...?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.