PCD spacer help

[smiff]

Ive been some digging on the site and i can't seem to get my answer.Im putting some porsche twists on my cupra tdi wheel sizes are 7x17 et55 fronts and 8.5x17 et50 rears basicly what size pcd adaptors do i need with to much poke i saw that luke c had the 7's allround with but with no pcd adaptor sizes thanks

 

[Pew.]

Pretty sure the twists are pcd 5*130 and the cupra is 5*100

Sent from my XT910 Razr

 

[smiff]

Sorry i should of made it clear the thickness of the spacers not the stud diamiter thanks though

 

[FR_MATT]

if he had twists he must of had adapters?

To get this:
http://www.seatcupra.net/forums/showpost.php?p=3831462&postcount=412
figures...
http://www.seatcupra.net/forums/showpost.php?p=3846744&postcount=423

Would be:
55-30 = 25mm adapter at the front
50-20 = 30mm adapter at the rear

 

[FR_MATT]

I'm not sure they will fit over your brakes though people have terrible trouble with the AP calipers

 

[broom]

im building up a set of rh zw1 s for my petrol cupra , the brakes are an absolute bitch 4 wheels , im having to run 40 mm spacers on each corner with just the right gap 4 clearance on the 4 pots, they are 8x17 all rnd on an offset of 60 , so would b around the 20 mark front and rear with the spacers so u should b ok mate

 

[vroomtshh]

I'm not sure they will fit over your brakes though people have terrible trouble with the AP calipers

Correct. Twists won't fit without mahoosive spacers

 

[smiff]

Damm it going have to do some trail and error i think thanks for all of your help guys

 

[wenman]

Get a picture up of the inside of the wheel.
I would assume Porsche wheels will have quite good clearance.
The RH ZW1's Broom is fitting have a curve near the top of the spoke on the inside which foul the brakes, meaning 40mm spacers to get them to clear!

 

[smiff]

No inside pics but these are the wheels