got the tracking done, then took the car for a blast and gained 8 ftlb over my previous runs while running lower boost
I want one of those so badly!
what have you done to your car today ?
- Thread starter seatcupramad23
- Start date
I want one of those so badly!
Yesterday I fitted my new timing belt and metal impeller water pump plus I retro fitted cruise control. Today I replace the broken relay in the comfort control module with a new one, now I have electricity again! I also put on the summer wheels in hope of no more snow, fitted my ***** fin antenna and gave her a good old clean!!
All in all she's been well pampered this weekend!
All in all she's been well pampered this weekend!
Today I gave the old girl a valet, and carbon wrapped the black bits between front and rear doors.
Yesterday I fitted the glove box storage box in place of the 6 cd changer and ordered my new Miltek exhaust from JKM Performance in Portsmouth.
Yesterday I fitted the glove box storage box in place of the 6 cd changer and ordered my new Miltek exhaust from JKM Performance in Portsmouth.
pumpkin_heed
Guest
Towed my cupra back to the garage I bought it from in leeds as it decided that it wanted to blow the engine up yesturday...... Thank god for warranty!
PJ1
Guest
Went back to The Phirm to finish off my Revo Stage 1 remap. Replaced the dodgy looking ebay air induction unit that came with the car when i bought it (chrome cone looking thing lol) with a new standard air filter and original air box. Initial increase was upto 190bhp now with a better air flow she is now reading 206bhp and a shed load of mid range torque lol
I am a very happy bunny now
Big thanks to Paul and Tim at The Phirm for a friendly and professional service.
I am a very happy bunny now
Big thanks to Paul and Tim at The Phirm for a friendly and professional service.
Last edited by a moderator:
Fitted some LED side light bulbs today, although now my EPC light is on :S any hints?
Where did you get the glovebox replacement from?
Where did you get the glovebox replacement from?
Pollen filter changed 
Pipercross panel filter fitted
Bookd car in tomorrow for Cat Back non resonated exhaust with twin 3" upswept tip
Pipercross panel filter fitted
Bookd car in tomorrow for Cat Back non resonated exhaust with twin 3" upswept tip
fitted fmic last week, ordered drilled and grooved discs and red stuff pads on monday which turned up today so will be fitting them tomorrow.
Fitted my porsche twist wheels,after fitting my yoko paradas to them,adjusted my coilovers,fitted my shallow sump and cleaned the drive from the mess left from my old sump(stupid speed bumps thinken they can put holes in my sump,now try!!!)
FItted a new filter.
The other previous one was a bit small
Old and new.
New fitted.
The other previous one was a bit small
Old and new.
New fitted.
Last edited:
offitmassive
Guest
Ordered me my new dog bone mount from awesome, 4 new bolts for it were ordered and arrived monday. found an old air duct kicking around at work so ripped old squashed piping out and fitted the air duct...
After Reading Poliq's Thread Link about swapping out the Rear Fog lamps for extra Tail lamps - I decided that as I cannot remember the last time I used the rear fogs I too would swap mine.
Before - Tail and Fogs on
Halfway - Offside swapped
Done - both swapped
So basically so far I have used 5w side lamps to replace fog lamps!
Before - Tail and Fogs on
Halfway - Offside swapped
Done - both swapped
So basically so far I have used 5w side lamps to replace fog lamps!
nice ideaAfter Reading Poliq's Thread Link about swapping out the Rear Fog lamps for extra Tail lamps - I decided that as I cannot remember the last time I used the rear fogs I too would swap mine.
Before - Tail and Fogs on
Halfway - Offside swapped
Done - both swapped
So basically so far I have used 5w side lamps to replace fog lamps!
Similar threads
