what have you done to your car today ?
- Thread starter seatcupramad23
- Start date
Make one yourself all you need is a bolt a nut and some washers http://www.seatcupra.net/forums/showthread.php?t=272564
DIY short shift, very pleased! Ordered coilovers, cupra r powerflex top mounts and powerflex front wishbone bushes 
watch this space
watch this space
Received my heat shield late yersterday and fitted today
Shield
Before
After
I got 1 of those £28 off the bay.
Replaced split OEM breather pipe with a red Silicon wrapped version.
Vinyle wrapped gearstick surround and door pillars; see http://www.seatcupra.net/forums/showthread.php?p=4098832&posted=1#post4098832
Vinyle wrapped gearstick surround and door pillars; see http://www.seatcupra.net/forums/showthread.php?p=4098832&posted=1#post4098832
Washed and hoovered it. And yesterday I took theses poxy spacers off http://i700.photobucket.com/albums/ww6/sideparting123/photo-13.jpg
as someone had fitted two and the wheel didn't sit on the hub properly a bit dangerous in my opinion. Also fitted my lcr front splitter .
as someone had fitted two and the wheel didn't sit on the hub properly a bit dangerous in my opinion. Also fitted my lcr front splitter .
Last edited:
CAL LOOK 58
Guest
Fitted 20mm rear spacers and the first good wash in months.......had to resist winding it back down to summer ride height though
Have some 13mm spacers for the front but need to find longer locking wheel bolts first.
CAL LOOK 58
Guest
I like those twin pipes, what exhaust is that?
I made my own cold air feed today with some ally ducting and hammer and chisel
now let's hope the rain water stays out long enough for me to feel the benefit!
CAL LOOK 58
Guest
It's a miltek cat back system, think the tailpipes are called gt80's? Since putting the Cupra R bumpers on I had thought about swapping for a single oval pipe instead, fit the cut out a little better.
Similar threads
