what have you done to your car today ?
- Thread starter seatcupramad23
- Start date
Hard to tell, to be honest, but I need the lower cover that covers up the crankshaft, water pump etc. This is roughly what I can see when I have the side undertray taken off:
Does this help?
Sent from my iPhone using Tapatalk
Looking at your picture again, it looks like I need that, and the bottom cover - so the whole lot comes in three parts - top, middle and bottom? I'm pretty sure I've only got the top one. I've got the ARL too and I know that the earlier engines (pre-2002 I think) had a different setup with the tensioner, so if yours is about the same age as mine, that cover should fit.
This part?
I'll need to have a closer look at what's going on, but I can't see that I'd be missing this part as well, so it sounds like all I need is the part that you've got that goes between the top cover and the bit above.
Sounds like I just need the bit you've got - I really appreciate you going to all this effort - when I've just got this empty space there at the moment I've no idea what's supposed to be there.
Of course, it looks like I need bolts as well...
I'd check as it needs to come off when the timing belt gets done
It's a relief that I can find the parts online - I'd be very surprised if the bottom cover is missing as well, as I'm sure that would have already caused issues with the accessory belt.
I'd be happy to take your middle cover off your hands. No worries if not though - it looks like I can get hold of one from eBay.
If you know what size bolts I'll need as well, that'd be awesome. Looking around, it sounds like they're 13mm heads, but I can't find anything reliable when it comes to anything else.
Sent from my iPhone using Tapatalk
M6x16 bolts. As for the bottom part, famous last words ?
Yeah, you can have my spare, includes bolts. DM me
M6x16 bolts. As for the bottom part, famous last words
Yeah, you can have my spare, includes bolts. DM me
Sent - thanks so much.
Sent from my iPhone using Tapatalk
So have an issue with my cluster, when ignition on or driving if I bump the top of the dashboard all the warning lights come on and the needles judder down to zero then return back to normal
I’ve taken out cluster to check for loose wiring but none found
Anyone able to help with suggestions
Sent from my iPhone using Tapatalk
I’ve taken out cluster to check for loose wiring but none found
Anyone able to help with suggestions
Sent from my iPhone using Tapatalk
So have an issue with my cluster, when ignition on or driving if I bump the top of the dashboard all the warning lights come on and the needles judder down to zero then return back to normal
I’ve taken out cluster to check for loose wiring but none found
Anyone able to help with suggestions
Sent from my iPhone using Tapatalk
I had my lights staying illuminate. The back of the board had a light film on it of water vapour ad what looked like salt residue. Cleaned it off and problem solved
Sent from my iPhone using Tapatalk
Yeah. Remove the needles and it’s quite simple. Just took a soft brush to the board brushed all the crap off left it to air off then put it back in
Sent from my iPhone using Tapatalk
Cheers mate, looks like I’ll be pulling the cluster out again 
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Similar threads
