dv fitting

[Cupra-cal]

was wondering if there is a step by step guide to fitting a forge 007p dv.i ve tried the search button but not had any joy

 

[gezmeister]

All you have to do is take the engine cover off. Then remove the 1 use clips on the 25mm connections on the dump valve. Remove bosch oem dv and replace with 007, using 2 new jubilee clips.
Job done

 

[Cupra-cal]

is the dv at the top of the engine to the back of the engine bay,gez?

 

[gezmeister]

Yup, black with a hose going into the bottom and left hand side as you look at it

 

[Cupra-cal]

cool thought that.what about the wee hole on the top of the valve what gets connected to that???

 

[godber225r]

There is a small pipe on top of the dv use a 10mm clip for that. its very self explanetary when you see it.

as mentioned before use new clips when installing new dv

Its so easy

 

[auq]

simple straight swap mate

 

[Twiggy86]

So how long do you reckon it would take to swap it over? Also is this the same thing for a "flutter" valve?

 

[gazR]

So how long do you reckon it would take to swap it over? Also is this the same thing for a "flutter" valve?

only a few minutes to put a d/v in. a flutter will take more time as its needs adjusting once installed

 

[adam cupra 20vt]

So how long do you reckon it would take to swap it over? Also is this the same thing for a "flutter" valve?

The flutter noise is usually wastegate chatter through the air filter.

New valve is very easy to fit....its getting the stupid single use clips off the old one thats the pain.

 

[andycupra]

if someone asked me to fit one and had the new jubilee clips ready id say it would take less than 5 mins and that wouldnt be rushing it.
Of course ive done this before so its easier than for a first time...
As above the tricky bit is removing the old clips on the pipes as these are once fit types.