-
Guest, New Stock alert: Premium CUPRA valve caps now available in the store ? Order now from the merchandise store
Dunno if you had the same ordeal trying to get the b*****ding thing to fit?
I ended up spraying it with silicon release spray to get it to slide on to the turbo!
I was also a bit miffed when i got it back as i thought the discs were on backwards, but apparently you can have them on either way and it makes no difference.
I ended up spraying it with silicon release spray to get it to slide on to the turbo!
I was also a bit miffed when i got it back as i thought the discs were on backwards, but apparently you can have them on either way and it makes no difference.
Previous owner fitted it, but i had it out to fit my boost gauge. Not too difficult to fit, only thing is you have to cut out the frame that goes between the radio and the wee shelf thing.
Mines a VW one from a Touareg, so its dead easy to wire in, and clicks home into the hole perfectly cos its an original VW part
Mines a VW one from a Touareg, so its dead easy to wire in, and clicks home into the hole perfectly cos its an original VW part
and down the sides damien.
might be a replacement trim from the touareg.
doesnt look like it sits flush at the bottom either. or does it fit flush guffers?
might be a replacement trim from the touareg.
doesnt look like it sits flush at the bottom either. or does it fit flush guffers?
the top bit with the hazard button etc is cut as it goes down the sides, then theres a rubber/plastic trim bit that gets pushed into the gap round the sides and bottom.
To take it out you peel the rubber out and then slide in two screwdrives to the bottom and unclip two tabs, then it all comes out.
Cupholder is a hole atm as it used to have a thing that you could plug your phone into and charge it, but i dont have the right make so i took it out. QUite a good idea tho, its like the stand chargers for the Sony ericsson phones but rewired and stuck in the dash. Sit you're phone on it and it charges. Only prob is i cant find one for a Blackberry.
To take it out you peel the rubber out and then slide in two screwdrives to the bottom and unclip two tabs, then it all comes out.
Cupholder is a hole atm as it used to have a thing that you could plug your phone into and charge it, but i dont have the right make so i took it out. QUite a good idea tho, its like the stand chargers for the Sony ericsson phones but rewired and stuck in the dash. Sit you're phone on it and it charges. Only prob is i cant find one for a Blackberry.
Last edited:
because im feeling kind and dont have much else to do right now ive just gone and checked for you its 4 1/2cm. thats the bottom of the boot lid to the bottom of the letter. 
because im feeling kind and dont have much else to do right now ive just gone and checked for you its 4 1/2cm. thats the bottom of the boot lid to the bottom of the letter.
You really are a very awesome person!
Last edited:
awesome look mate. did you paint the rear SEAT badge?
Previous owner painted the whole thing black, so i painted the background red for some definition, found out it looked a bit weird so took the black back to original silver but left the back red.
I think.....
Similar threads
