Hi looking for some advice.Thanks again for the pin identification... I managed to install one on my underseat subs during the week and all working great.. No issues, Inc unwanted noise, coming from sub...
What I will say now is I did have to hunt for the front door speaker wires to tap into for my speaker (high) level input...
This pic shows the 8 speaker pins....
Which is good but the middle 4 pins showing the front speakers are for the pillar tweeters...
The pins for the door speakers are these:
I found them using my phone with a cable out of headphone jack and just prodded and poked until sound came out of door speakers....
Now I've done one, I will do the other for, passenger seat, when I get time... And i will post up some install pics too...
I've installed my alpine 8 inch subwoofer with build in amp today. I've connected the rca to speaker wires left and right front as shown in picture. Not sure if I should of connected them to rear speakers as don't seem to be getting much bass out of them when adjusting the gain on wired control panel. It doesn't state front or rear connection in manual so not sure what wrong as sub had lots more base in my old mk2 leon. Thanks