The brembo's cost around £1300 fitted, but spacers(both axles) to allow alloys to clear calipers took total to £1450. Nothing done to rear brakes yet, i'm considering S3 or cupra rear brakes.
It is done, the DPF has gone.
Now with 230.4 bhp at about 4500rpm and 329.5lb/ft torque.
I'll post some pics of the milltek exhaust as well soon, but the car is beast compared to what it used to be
Now with 230.4 bhp at about 4500rpm and 329.5lb/ft torque.
I'll post some pics of the milltek exhaust as well soon, but the car is beast compared to what it used to be
Sounds good man. Your making me want mine done even more now lol everything went ok whilst doing it then?
Yeah everything when fine, just need to get used to the responsiveness. It's always wanting to let fly now it's not restricted by the dpf
It is done, the DPF has gone.
Now with 230.4 bhp at about 4500rpm and 329.5lb/ft torque.
I'll post some pics of the milltek exhaust as well soon, but the car is beast compared to what it used to be
Sounds a bit low compared to others no? What pipes did you get for the cat back?
Alex
according to james at jbs mine was just above average for torque. power wise i'm down on AndrewJB by about 5 horses. It still goes link stink tho
I went for the 76mm twin jet
I'm just upgrading to brembos myself, what size spacers did you have to use to clear the original 18" alloys?
10mm spacers all round mate. hope this helps
Thanks very much, most appreciated
DPF delete MOT pass
just had my car MOT'd yesterday and it passed. Even with HID's it passed Was a little worried before the car went in, but huge relief when i got the call that car was ready to be picked up.
just had my car MOT'd yesterday and it passed. Even with HID's it passed
Was a little worried before the car went in, but huge relief when i got the call that car was ready to be picked up.
just had my car MOT'd yesterday and it passed. Even with HID's it passed
Chan on your Mot Paperwork does it give your smoke figure?
its measured in M-1
It should give some kind of idea to what mine should be producing, My MOT is due after the new rules come in so if yours is 1.5M-1 or above it means mine will prob fail
Are these spacers hub centric? If yes do they fit on rear axle without any problems?10mm spacers all round mate. hope this helps
Similar threads
