SNAP

DSCN1621.jpg

:D

never seen a mk1 badgless grill:confused: can't figure out if i like it or not, which is strange because i'm normally love it or hate it kinda guy:blink: how much was it? and where from bud? nice car anyway bud keep up the good work;)
 
Got my shades on they are very good, sunlight does comes through very slightly, due to the mesh being perforated.

Bloody hard to photograph lol i'll try again when no reflections are about.

dscf0202a.jpg

dscf0203.jpg

dscf0204.jpg

dscf0205.jpg
 
Nice. Did you do them yourself? I have rolls on tint film but have never bothered trying to install on the car.
Would you tint the clear parts of the rear lights?
Have done mine and think it looks much better. Especially in the colour our cars are in.
 
Them come ready made and are held in my there own pressure, you can just see the clips on the open door, one is by the tag.
They are on the boot glass too, harder to see.
Yeah rears do need tinting.
Whilst your here remember i said about the scangauge reading 75 deg and you agreed yours was too, i changed the thermostat and it now reads 90 deg, worth changing MPG as improved ;)
 
Hmmm... thats interesting. Ill check it out later as to what it is reading - now the weather is slightly warmer. If at 75 ill change the thermostat as you said - am only always getting around 26mpg. (230 miles at were the needle moves left of quarter full)
 
Looking good Lee. Guess you got the sun shades for the little one? Aren't they quite expensive? Did look at them a while back for the Touran and our little ones but they didn't do them. Been quoted around 200 for tints.
 
Bottom of the a pillar.
Yeah good little gauge tbh

dsc03413jn5.jpg

nice to see another pre facelift....not many of us left now:(

what is that gauge thing you have? what does it do, how much and where from?:D
 
Now have my Angel eyes to be "modded" and fitted.
For anyone who want's to do the same as i am follow these basic instructions.

Remove the 4 clips holding the lens to the outer case

clip.jpg



Then they split like this

DSCF0189.jpg


Then break the seals holding the plastic to the actual front lens

DSCF0191.jpg


Then pop out the plastic "angel eyes" and remove the indicator bulb cover

DSCF0192.jpg


And it leaves you with the carcass to spray black :D

DSCF0193.jpg


I shall update this when i have sprayed them, i am waiting on some H1 hid bulbs arriving to make full use of the projectors :D