Rough/"Misfire" Idle

[K8VXT]

Hi Guys

I am having some problems with a rough misfire sort of idle (Seat Cupra 280 DSG 2014)

So first thing I did was ran codes on the car, 2 errors were stores and but they did not chuck an EML light.

- P006800 MAP / MAF - Throttle Position Correlation
- P227900 Passive/Abiogenesis Intake Air System Leak

After running these I went with the most obvious part to change, the PCV.

Replaced that and however, I am still getting a rough idle.

At this point I'm open to what people suggest, anyone experienced this or know what to do next.?

Thanks,
Kavit

 

[Cuprabenwytm]

Does your engine wobble on tickova , my 290 does this but when i took it in they said nothings up

Sent from my MRD-LX1 using Tapatalk

 

[K8VXT]

Yeah a little with my 280 tbh, weird.

This is issue I'm having is on idle and the engines warm.
No jump in revs just a rough wobble.

 

[Cuprabenwytm]

Mines exactly the same revs dont move but the engine wobbles about, im. Gunna take it back. Now av seen your diagnostics

Sent from my MRD-LX1 using Tapatalk

 

[andycupra]

unplug the maf, does it get better?

 

[K8VXT]

unplug the maf, does it get better?

Stupid question but where is the MAF it wasn’t on the air intake?

 

[hypervisor]

Got the same issue on my 290, misfire on warm idle only, did you get yours fixed?

Hi Guys

I am having some problems with a rough misfire sort of idle (Seat Cupra 280 DSG 2014)

So first thing I did was ran codes on the car, 2 errors were stores and but they did not chuck an EML light.

- P006800 MAP / MAF - Throttle Position Correlation
- P227900 Passive/Abiogenesis Intake Air System Leak

After running these I went with the most obvious part to change, the PCV.

Replaced that and however, I am still getting a rough idle.

At this point I'm open to what people suggest, anyone experienced this or know what to do next.?

Thanks,
Kavit

View attachment 19375View attachment 19377

 

[K8VXT]

Got the same issue on my 290, misfire on warm idle only, did you get yours fixed?

Unfortunately still a problem, they said to wait until it gives a EML or its obvious where the leak is (trying to find somewhere that does a smoke test)

My suggestion would be for you to plug in an OBD see if there is any stored errors.