where do you plumb your catch tank into

[PhilW]

Is your connection to inlte manifold blanked?

I ran a catch tank inline from the rocker breather to TIP only before and it didnt catcha great deal of stuff.

 

[h17och]

im still connected to inlet....shall i just plug that then?

 

[PhilW]

Thats what i have done and remove the valve in the t-piece that the inlet manifold conenction goes to.

 

[h17och]

so youve come stright from crankcase up? no T?

normal silicone ok or the pricey oil/fuel stuff

 

[p34ch3y]

And a small pic of the amount of crap that my catch tank picked up after two months. All this would have either gone down the TIP/blown onto the MAF or been sucked into the inlet mani...

Not nice is it.

thats the same catch tank as mine so just to clear this up phil blank of inlet manifolddpipe underneath remove the valve/tee bit and from catch tank one pipe in crank case tee piece bit that comes of it and is the other one straight in the TIP or just vented to atoms or lil breather filter on?

 

[p34ch3y]

Is your connection to inlte manifold blanked?

I ran a catch tank inline from the rocker breather to TIP only before and it didnt catcha great deal of stuff.

how are you running your catch tank now phil?

 

[PhilW]

As i've said, i've blanked the connection to the inlet manifold, removed the valve in the t-piece under the mani. Then its stock pipework up to the rocker breather which goes to my catch tank instead of to the TIP/mushroom which is blanked off now. Then my connection on the catch tank vents to atmos down in the wing.

 

[ibizacupra]

thats the same catch tank as mine so just to clear this up phil blank of inlet manifolddpipe underneath remove the valve/tee bit and from catch tank one pipe in crank case tee piece bit that comes of it and is the other one straight in the TIP or just vented to atoms or lil breather filter on?

thats a nice water/oil emulsion you have there

 

[PhilW]

thats a nice water/oil emulsion you have there

Anything to worry about from that?

Even tho my block has been stripped down now.

 

[DPJ]

Anything to worry about from that?

Even tho my block has been stripped down now.

Looks like it's doing its job to me, Phil.

 

[p34ch3y]

would i be right in saying i need 19mm hose to go on the tee thing

 

[PhilW]

I have a feeling its 15mm on the PCV t-piece thing. But 19mm off the hard pipe on the rocker breather.

Just measure it first.

 

[Spud_G40]

So what did you use to block off the valve on the inlet manifold?

 

[h17och]

its not a valve, just a connection. abit of hose and a correct size bolt would do!

 

[PhilW]

Yep, as hooch says. Cut the hose and jammed both ends with a bolt.

 

[h17och]

i just removed the valve. never even new it was there!

about to make sum ali plugs to block a few things off

HoocH

 

[Forbez]

Pics people pics!

 

[p34ch3y]

il be doing mine nxt week end from scratch il take some pics bit by bit on doing this and post them up

 

[v-g]

And a small pic of the amount of crap that my catch tank picked up after two months. All this would have either gone down the TIP/blown onto the MAF or been sucked into the inlet mani...

Not nice is it.

That does NOT look like something to do with cars... Yuck!

 

[p34ch3y]

got it all in at the weekend................GOD ant that PCV valve a real bitch to get out