Looking tip top Dave! Wish I’d known about the place in Fenton when I had mine done, would have saved me the trek to The Wheel Specialist in Manchester!
Matt.
Matt.
So, I stuck the discs on yesterday, the disc retainer was an absolute PITA. The head on it was like chocolate, no force and it crumbled.
So - before;
The half drilled retainer bastid
New disc on
Old disc face
Old disc back
And the end result
- Still bedding in as you can see.
So - before;
The half drilled retainer bastid
New disc on
Old disc face
Old disc back
And the end result
- Still bedding in as you can see.
looking good mate. be some good braking there . i wanted some that matched the back but didnt get any
you needed to use an impact driver on that screw so it didnt crumble on you makes life much easier,brakes look good though.
Ha, wasn't one on hand! Done now anyway - Got different and zinc plated screws in now, so hopefully it shouldn't be an issue next time.
MoT was meant to be today, however they can't test it as their ramps are too high. It's now booked into the place I had it done last year, but that's another 5 days with no decat Bored of standard power now..
MoT was meant to be today, however they can't test it as their ramps are too high. It's now booked into the place I had it done last year, but that's another 5 days with no decat
Bored of standard power now..Re: Mr_Dave's Ovni Yellow LCR - New brakes @ Page 27
Got a couple of exhaust videos tonight now the decat is back on, nothing special and the first part is out of focus because the camera wasn't playing, but the important bit is all there
As follows 
Moved to photobucket, see below.
Got a couple of exhaust videos tonight now the decat is back on, nothing special and the first part is out of focus because the camera wasn't playing, but the important bit is all there
As follows
Moved to photobucket, see below.
Last edited:
cheers, it's all good fun 
