I managed to get the cover rubbed down and lacquired today :D

untitled-18-2.jpg


untitled-19-2.jpg


Lacquired
untitled-20-2.jpg


untitled-21-2.jpg


Next stage will be to polish out the imperfection's which there are quite a few and then it'll be ready to fit :D
 
Have you seem the RS4 in this months PVW?? engine is lots of carbon/black and some hints of Red.
 
Just been out and trial fitted the cover and it still fit's :D

untitled-73-2.jpg


untitled-74-1.jpg


untitled-75-1.jpg


untitled-76-1.jpg


untitled-77-1.jpg


It needs another rub down, theres a few small airbubble holes that need rubing out and as always I got a few run's in the lacquire :(
 
Thats one tidy bay. Nice bit of handywork!
Havnt even got myself a leon yet and I want one too! :D
 
Thanks for the quick bay detail mate! :)

Pics look brill. The stance on your car is near spot on now from seeing it before.

The S3 cover looks the nuts up close, can't wait to see it fitted!
 
Finishes it off nicely mate. Any more probably would be OTT but not sure what else you could do in the bay. Could you not get some black silicone hose repair tape to wrap sround the red wire? just a thought.
 
Is this an audi s3 part then? Is it an aftermarket product youve improved on or a standard cover that you have covered in carbon?
 
I think I want to run my tongue over the entire bay - looks tasty :D

:lol:

Finishes it off nicely mate. Any more probably would be OTT but not sure what else you could do in the bay. Could you not get some black silicone hose repair tape to wrap sround the red wire? just a thought.

I have got a bit heat wrap to go over that but not got round to it yet :whistle:

I think your going to have to do the s3 battery cover now too

I'm not too keen on the S3 battery cover :think:

Is this an audi s3 part then? Is it an aftermarket product youve improved on or a standard cover that you have covered in carbon?

It started out as an S3 cover but it had to be extended to fit properly, then it was wraped in Carbon Fibre.
 
yeah way too much.....

i'll take bits off your hand straight swap for the OEM parts :funk::whistle::funk:

You should only keep the charge pipe small holder only..........;)
 
Hi, great car.Have you tought about wraping your rims in carbon fiber, since you like it so much? I've seen some rims covered with leather, so why not try carbon fiber look? ;)