My splitter used to look like that...nice and smooth round the edges with the small chamfer...now its a little worn and 'chewed' after a few encounters with speed bumps, and trying to reverse onto me drive 
Looks good though!!
Looks good though!!
Thats something to look forward to then. How low is yours then, ive got my coilovers just need to get em fitted. I was thinking of dropping them about 40mm back and front.
I never did measure how much i lowered it by...i measured 45mm on the rear coil overs from the last thread to the bottom of the adjustment bolt thing.
The front measures 570mm from the ground up to the very highest point of the arch. Not a very accurate measurement but gives an idea.
It's the lowest it will go at the moment...as i can't get the car on or off the drive any lower...but i move house in a few weeks so...
Looks good, agreed about a cupra front bumper, but aint cheap. Ive got cupra alloys on mine and 20mm spacers, the lower sidewall and wider width on the tyres for the cupra alloys helps with cornering alot.
richstani153
Guest
In response to a few questions, im not sure how much its lowered by, its on coilovers and i just got the top of the arches lined up with the tyres...
i think lips just clip on, the car came with them sprayed so i havent had to take them off.
to cut out the bits on the front lip i had to drill them a then cut out with a coping saw. hope that helps.
i think lips just clip on, the car came with them sprayed so i havent had to take them off.
to cut out the bits on the front lip i had to drill them a then cut out with a coping saw. hope that helps.
Similar threads
