Removing N249 valve - How To Guide

[h17och]

did you put the right resistors in?

HoocH

 

[ibizacupra]

did you put the right resistors in?

HoocH

"I" did'nt do the job.... and no they did'nt.. 1/2watt resistor = smouldering/melted insulation and cable duct

but I sure "undid" the bodge when I burnt my arm on it whilst working over the engine.

 

[Simon L]

Did the today, only thin i really noticed that part throttle was a bit smoother.

What does the "box" with the 2 vac lines going in and out, above the vacuum chamber do?

 

[Simon L]

Read Sims guide and found its the N112 (Secondary air injection valve).

 

[Simon L]

What size of vac line should i be ordering for these pipes?

I fancy changing the braided stuff for some samco.

 

[GaryM]

What size of vac line should i be ordering for these pipes?

I fancy changing the braided stuff for some samco.

He says 4mm ID on the first post like THIS from Forge Motorsport.

 

[Icecavern]

Dont suppose anyone has a pic of an LCR with this mod done? I'm after doing this to uncover the bling arriving next week

 

[Simon L]

Cheers Gary.

 

[Simon L]

Also noticed faster DV response time, less lag between gear changes.

 

[Copra]

been reading this. i gues you could extend the loom that plugs into the n249 valve, and instead of using a resistor block, use the proper valve, just remotely fitted, ie under scuttle pannel in a little bag or something?
its something i always wanted to do while i owned my cupra, and im sure i will do it this time round

 

[h17och]

Yes mate, what your saying makes sence! never thought of it myself!!

 

[Copra]

just sounds a bit easier than making a board of resisors (not that its hard though) hey im just lazy...looking for the easiest route

 

[Copra]

p.s your sig..

"Why drive forwards....when you can slide sideways!?! "

yeah well i did that in my previous car and i can assure you its best to drive forward

 

[h17och]

loads more fun drifting!

its not very good for the car tho in front wheel drive, dont do i soo much in this car, F$£ked to many things up on previous cars!!

are you talking about the rx8?

HoocH

 

[Copra]

na, my rx8 is in the trader

 

[PhilW]

been reading this. i gues you could extend the loom that plugs into the n249 valve, and instead of using a resistor block, use the proper valve, just remotely fitted, ie under scuttle pannel in a little bag or something?
its something i always wanted to do while i owned my cupra, and im sure i will do it this time round

This is something jonzy is doin actually, i;m gonna see what he's done and used before i do mine. When i get the rocker cover polished i need to ditch the awful thing.

 

[Simon L]

When you do this, you can actually remove the vacuum chamber. But you need to leave the plate the holds the two valves though.

If you are gonna remove it? What are you going to do with the N112? Extend it out the way also?

 

[Jonzy]

Ill be re-locating the lot this afternoon, finally got all the connectors today. Currently ziptie'd to the charge carrier

 

[davidol]

matt get some pics up, im stuck in work but cant wait to see this!

 

[Jonzy]

Yep